AC800 Wafer Cleaning

Adaptation range:

It is mainly used in the industry of material preparation, solar cell chip, discrete device and so onEightThe cutting and drying process of the wafer or device after the cutting.


Main features:

☑ The technical adaptability is strong, and the special work table can be customized.

☑ The precision of dynamic balance is high and the reliability is strong, which ensures the stable operation of the equipment.

☑ A variety of cleaning mode, optional two fluid cleaning, nitrogen cleaning, ultra high pressure cleaning and other modes;

☑ PLC full automatic control, touch control operation, parameter and cleaning mode intelligent editing, simple and convenient operation.

☑ A variety of cleaning mode, optional two fluid cleaning, nitrogen cleaning, ultra high pressure cleaning and other modes;

☑ PLC full automatic control, touch control operation, parameter and cleaning mode intelligent editing, simple and convenient operation.


Detail

Technical indicators:

Maximum working size

mm

island 8 "or160mm×160mmsquare

Working speed

r/min

100 - 2400

Anti clamp hand device

-

Standard

Other

Specifications

 

 

 

 

 

 

 

 

 

 

 

 

 

Power Supply

 v

two-phaseac220v±Ten

In addition to the above, the transformer needs to be configured

Power consumption

Processing time

 kw 

Zero point eight(reference value)

Warmer time

 kw 

Zero point two(reference value)

Compressed air supply pressure

 Mpa 

0.5 - 0.8

Maximum compressed air consumption

L/minANR

Two hundred

DIwater pressure

Mpa

0.25 - 0.4

DIMaximum water consumption

L/min

Six

NTwopressure

Mpa

0.25 - 0.4

NTwoMaximum consumption

L/min

Two hundredMax

Exhaust air volume

mThree/min

Two

Equipment size (W×D×H

mm

Four hundred×Six hundred×One thousand and two hundredSixInches)

Equipment weight

kg

aboutOne hundred

Conditions of use:

1. please set the machine in a 20~25 C environment (the range of fluctuation is within + 1 c); the indoor humidity is less than 80%, and there is no condensation.

2. please use the air pressure dew point below -15 C, the residual oil is 0.1ppm, the filtration degree is above 0.01um/99.5, clean compressed air.

3., please control the water temperature of the cutting water at room temperature of +2 C (within the range of + 1 c), and the water temperature of the cooling water is the same as that of the room temperature (the fluctuation range is controlled at + 1 degrees Celsius).

4. please avoid the gravity impact of the equipment and any vibration threat from the outside world. In addition, please do not install the equipment near the blower, the vent, the high temperature device and the oil producing device.

5. please install the equipment in a waterproof floor and a place with drainage treatment.

6. please do the operation in strict accordance with the instructions of the company's products.  


Contact us
 

ChangShu:

TEL:+86-512-5296-9660

PHO:+86-139-1043-2532 Sam Yang

ADD:Changshu Economic & Technological Development Zone

Email:jcxj_support@163.com

Web:http://www.jcxj.com.cn



Scan QR codeClose